Cartridge Heaters

Home » Products » Cartridge Heaters

For the High Density Cartridge Heaters, you can rely on Anish Enterprises. We offer a qualitative range of Cartridge Heaters that are used wherein limited heat is required like in dies, plates, packaging, moulds etc. Electric Cartridge Heaters are manufactured in S.S, brass, incoloy sheathing in plain and in D type with high and low density wattage. These cartridge heaters are used in assortment of industries. Apart from this, we ensure availability of High Density Cartridge Heaters at the cost effective prices.

Construction

Heater tip rolled to hold in place.

Mica.

Sheath Material: Stainless steel 304/316/ Incloy Brass.

Element wire situated in close proximity to outside surface for maximum heat transfer and minimum internal temperature while preserving good dielectric qualities.
Magnesium oxide grain packing.

Ceramic Porcelain support.

Ceramic cap.

Teflon insulated leads / Fiberglass leads / Post terminals

Features

Wide variety of special requirements , sizes & Terminations

Cartridge Heaters can be dual-voltage, three phase, and/or be supplied with a ground terminal & different termination styles, Low voltage (12 or 24 Volt) possible

Braided Wire, straight or right angle exit available.

Max temperature for SS tube 400 °C, for Brass tubes 200 °C.

Diameters: As per the customers specifications or requirement.

Length - Available in any desired length

Choice of lead lengths

Application

Plastic molding

Packaging equipment

Heating tanks

Plastic extruders

Labeling machinery

Gas and liquid heating

Select Language: